Dell PowerEdge RAID Controller 11 User’s Guide PERC H755, H750, H355, and H350 Controller Series

PDF

Using disk roaming

About this task

Perform the following steps to use disk roaming:

Steps

  1. Turn off the power to the system, physical disks, enclosures, and system components.
  2. Disconnect power cables from the system.
  3. Move the physical disks to desired positions on the backplane or the enclosure.
  4. Perform a safety check. Make sure the physical disks are inserted properly.
  5. Turn on the system.

Results

The controller detects the RAID configuration from the configuration data on the physical disks.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\