Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products

Dell PowerEdge RAID Controller 11 User’s Guide PERC H755, H750, H355, and H350 Controller Series

Remove the PERC H755N front NVMe card

Prerequisites

CAUTION:Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior of the system.

Steps

  1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
    NOTE:Perform a graceful shutdown of the system to ensure that data in the cache is moved to the disk before the controller is removed.
  2. Open the system.
  3. Locate the PERC card in the controller carrier at the front of the system.
    CAUTION:To prevent damage to the card, you must hold the card by its edges only.
  4. Unscrew the fasteners on the controller carrier, and slide the carrier away from the backplane to disconnect the controller from the backplane.

    If you are removing a PERC H755N front NVMe controller in the upside down orientation, you must remove both the backplane and the controller at the same time because of the limited clearance available:

    1. Uninstall all drives from the backplane.
    2. Disconnect all cables between the PERC and the backplane.
    3. Lift the backplane and PERC from the system.
  5. Disconnect any cables connected to the card:
    1. Press down and hold the metal tab on the cable connector.
    2. Pull the cable out of the connector.
  6. Remove the PERC controller from the controller carrier.
  7. Insert the replacement controller into the carrier and secure it with the appropriate screws.
  8. Take the replacement storage controller and reconnect the cable before reconnecting it to the backplane.

    If you are removing a PERC H755 front NVMe controller in the upside down orientation, reattach the PERC controller to the backplane first before reinstalling the backplane into the system.

  9. Close the system.
  10. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
    Figure 1. Remove the PERC H755N front NVMe card. This image shows how to remove a PERC H755N front NVMe card.
    Remove the PERC H755N front NVMe card

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\