- Notes, cautions, and warnings
- Introduction
- What is new in this release
- Supported SNMP Versions
- Managed Object Used in This Document
- Server Administrator Remote Access MIB
- Dell Remote Access Controller Out-of-Band MIB
- Basic Terminology
- Frequently Used Terms in Variable Names
- Tables
- Other Documents You May Need
- System Battery Table
- Amperage Probe Table
- Power Unit Group
- Power Supply Table
- Power Usage Table
- Voltage Probe Table
- System Information Group
- Chassis Management Controller Group
- OpenManage Enterprise-Modular Management Software Group
- SNMP Traps
- iDRAC MIB
SNMP Reference Guide for iDRAC, Chassis Management Controller and OpenManage Enterprise - Modular Management Software 1.30.00
iDRAC SNMP Data Security Features
iDRAC firmware supports the following data security features:
- SNMP security lockout feature
- iDRAC supports a simply, non-configurable SNMP security lockout feature. If more than six SNMPv3 USM authentication failures occur within a 2-minute window, then the iDRAC SNMP Agent blocks all subsequent SNMPv3 requests/queries for 10 minutes.
- Restriction of access to sensitive data
- Some of the MIB data that iDRAC supports can only be accessed via SNMPv3 queries. Access to such data is blocked for SNMPv1 and SNMPv2c queries.
- Currently, the following one attribute, and one table, are considered
to be “sensitive” data and have this restriction:
- numLCLogEntries (which has an SNMP OID of: 1.3.6.1.4.1.674.10892.5.4.300.2.0)
- lcLogTable (which has an SNMP OID of: 1.3.6.1.4.1.674.10892.5.4.300.90)
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\