This section
describes the traps that are generated by the SNMP agent of the Remote
Access Controller (RAC). All the enterprise-specific traps documented
in this section belong to the MIB enterprise identified by OID 1.3.6.1.4.1.674.10892.2
and are sent with all the trap variables documented in the section.
The trap variables are sent in the order in which they are listed.
NOTE The PowerEdge M1000e
CMC, PowerEdge VRTX CMC and PowerEdge FX2 CMC do not generate the
traps in this section. They generate the traps documented in the
CMC Traps.
Table 1. RAC TrapsThe following table describes the name, object
ID, description, syntax, and access level.
TrapID
Name
Description
Severity
Category
Cause
Supported by RAC Platform
0
CodeStart
SNMP agent is initializing itself
Information
Status
RAC power on or reset.
All
1
Authentication
Failure Request received with an invalid community
name
Critical
Error
SNMP request with an invalid community name.
All
1001
alertDrscTest TrapEvent
The RAC generated a test trap event in response
to a user request
Information
Status
A test SNMP trap generated by a RAC.
All
1002
alertDrscAuth Error
RAC Authentication failures during a time period
have exceeded a threshold
Minor
Error
RAC login failure caused by authentication failure,
number of concurrent logins exceed limit, or permission denied.
All
1015
alertDrscSEL
Warning The RAC has detected a new event in the
System Event Log with Severity: Warning
Major
Error
RAC detected a new system event log with warning
severity (detailed log info is in drsAlert Message varbind).
All
1016
alertDrscSEL
Critical The RAC has detected a new event in the
System Event Log with Severity: Critical
Critical
Error
RAC detected a new system event log with critical
severity (detailed log info is in drsAlert Message varbind).
All
1017
alertDrscSEL 80 percentFull
The RAC system event log is 80% full
Major
Status
RAC detected system event log is 80% full.
All
1018
alertDrscSEL 90 percentFull
The RAC system event log is 90% full
Major
Status
RAC detected system event log is 90% full.
All
1018
alertDrscSEL 90 percentFull
The RAC system event log is 90% full
Major
Status
RAC detected system event log is 90% full.
All
1020
alertDrscSEL Normal
The RAC has detected a new event in the System
Event Log with Severity: Normal
Information
Error
RAC detected a new system event log with normal
severity (detailed log info is in drsAlert Message varbind).
All
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\