The following table identifies the SNMP versions that
support iDRAC for the given SNMP operations.
Table 1. iDRAC Supported SNMP VersionsThe following table describes the SNMP Operations, GET, GETNEXT,
GETBULK, and the related Trap.
SNMP Operations
Supported SNMP version
GET, GETNEXT, GETBULK
SNMP v1, v2c and v3
TRAP
SNMP v1, SNMP v2c and SNMP v3
NOTE iDRAC does not
support the SNMP SET operation for any data.
NOTE iDRAC7 firmware
release r1.30.30 or later supports SNMP query operations
(GET, GETNEXT, GETBULK) through the SNMPv3 protocol. In addition to
supporting query operations through the SNMP v1 and SNMP v2c protocols,
SNMP User Security Model (USM) is supported.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\