NOTE This section
contains information that is applicable only if the Server Administrator
is installed in the system.
The Server Administrator Remote Access MIB ( filename dcs3rmt.mib ) provides in-band information about remote
access hardware that may be present in your system.
The Server Administrator Remote Access MIB structures
its MIB objects into groups of scalar objects or MIB tables that provide
related information. Table below describes each Server Administrator
Remote Access MIB group and lists the MIB group number assigned to
the MIB group. The Server Administrator Remote Access MIB groups are
identified by the SNMP OID 1.3.6.1.4.1.674.10892.1.<MIB group
number> where <MIB group number> is the MIB group number
assigned to the MIB group. See the relevant section for more information
about the MIB objects defined in a MIB group.
Table 1. Server Administrator
Remote Access MIB Sections in This GuideThis section contains information that is applicable only if
the Server Administrator is installed in the system.
Topic
MIB Group Numbers
Remote Access Group — provides information about
remote access hardware that may be present in your system and defines
variables for administrative users, SNMP trap destinations, modem
configuration for dial-up networking, dial-in configuration, and dial-out
destinations
1700
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\