- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Inspiron 24 5410 All-in-One
- Stand
- Back cover
- I/O cover
- Hinges
- Hard drive
- System-board shield
- Memory module
- Wireless card
- Solid-state drive
- Retractable-camera assembly
- Fan
- Speakers
- Coin-cell battery
- Heat sink
- Media-card reader
- Power-button board
- System board
- Microphones
- Antennas
- Display panel
- Base panel
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell Technologies
Inspiron 24 5410 All-in-One Service Manual
Installing the back cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the back cover and provides a visual representation of the installation procedure.
Steps
Align the slots on the back cover with the slots on the computer, and press along the side to snap the back cover into place.
Next steps
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\