- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Inspiron 24 5410 All-in-One
- Stand
- Back cover
- I/O cover
- Hinges
- Hard drive
- System-board shield
- Memory module
- Wireless card
- Solid-state drive
- Retractable-camera assembly
- Fan
- Speakers
- Coin-cell battery
- Heat sink
- Media-card reader
- Power-button board
- System board
- Microphones
- Antennas
- Display panel
- Base panel
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell Technologies
Inspiron 24 5410 All-in-One Service Manual
Installing the system-board shield
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the system-board shield and provides a visual representation of the installation procedure.
Steps
- Align the slots on the system-board shield with the ports on the computer.
- Replace the four screws (M3x5) that secure the system-board shield to the display-assembly base.
Next steps
- Install the I/O cover.
- Install the back cover.
- Install the stand.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\