Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Inspiron 24 5410 All-in-One Service Manual

PDF

Installing the system board

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the connectors on your system board.
Figure 1. System-board connectors
Image: System-board connectors
  1. Solid-state drive slot
  2. Touchscreen-cable connector (optional)
  3. Camera-cable connector
  4. Backlight-cable connector
  5. Fan-cable connector
  6. Coin-cell battery
  7. Memory-module slot (DIMM1)
  8. Memory-module slot (DIMM2)
  9. Speaker-cable connector
  10. Microphone-module cable connector
  11. Media-card reader cable connector
  12. Wireless-card slot
  13. Power-button board cable connector
  14. Display-cable connector

The following image indicates the location of system board and provides a visual representation of the installation procedure.

Image: Installing the system board

Image: Installing the system board

Steps

  1. Align the screw holes on the system board with the screw holes on the display-assembly base.
  2. Replace the six screws (M3x5) that secure the system board to the display-assembly base.
  3. Replace the solid-state drive screw mount (M3x4) that secures the system board to the display-assembly base.
  4. Connect the display cable to the system board and close the latch to secure the cable.
  5. Connect the power-button board cable to the system board and close the latch to secure the cable.
  6. Connect the media-card reader cable to the system board and close the latch to secure the cable.
  7. Connect the microphone-module cable to the system board.
  8. Connect the speaker cable to the system board.
  9. Connect the fan cable to the system board.
  10. Connect the backlight cable to the system board.
  11. Connect the camera cable to the system board.
  12. Connect the touchscreen cable to the system board.
    NOTE:This cable is only available on computers that support touch option.

Next steps

  1. Install the heat sink.
  2. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive, as applicable.
  3. Install the wireless card.
  4. Install the memory module.
  5. Install the system-board shield.
  6. Install the hard drive.
  7. Install the I/O cover.
  8. Install the back cover.
  9. Install the stand.
  10. Follow the procedure in After working inside your computer.
    NOTE:Your computer’s Service Tag is stored in the system board. You must enter the Service Tag in the BIOS setup program after you replace the system board.
    NOTE:Replacing the system board removes any changes that you have made to the BIOS using the BIOS setup program. You must make the appropriate changes again after you replace the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\