- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Inspiron 24 5410 All-in-One
- Stand
- Back cover
- I/O cover
- Hinges
- Hard drive
- System-board shield
- Memory module
- Wireless card
- Solid-state drive
- Retractable-camera assembly
- Fan
- Speakers
- Coin-cell battery
- Heat sink
- Media-card reader
- Power-button board
- System board
- Microphones
- Antennas
- Display panel
- Base panel
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell Technologies
Inspiron 24 5410 All-in-One Service Manual
Removing the antennas
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the stand.
- Remove the back cover.
- Remove the I/O cover.
- Remove the hard drive.
- Remove the system-board shield.
- Remove the media-card reader.
- Remove the memory module.
- Remove the wireless card.
- Remove the M.2 2230 solid-state drive or M.2 2280 solid-state drive, as applicable.
- Remove the heat sink.
- Remove the system board.
- Remove the speakers.
- Remove the display hinges.
- Remove the power-button board.
About this task
The following image indicates the location of the antennas and provides a visual representation of the removal procedure.
NOTE:Note the routing of the antenna cables, before removing the antenna cables form the routing guides. Also, note the location of the antenna modules printed on the display-assembly base as ANT-B (black) and ANT-W (white).
Steps
- Remove the antenna cables from the routing guides on the display-assembly base.
- Carefully peel the copper foil that secures the antenna cables on both sides of the display-assembly base.
- Lift the antenna modules off the base panel.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\