- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Inspiron 24 5410 All-in-One
- Stand
- Back cover
- I/O cover
- Hinges
- Hard drive
- System-board shield
- Memory module
- Wireless card
- Solid-state drive
- Retractable-camera assembly
- Fan
- Speakers
- Coin-cell battery
- Heat sink
- Media-card reader
- Power-button board
- System board
- Microphones
- Antennas
- Display panel
- Base panel
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell Technologies
Inspiron 24 5410 All-in-One Service Manual
Removing the stand
Prerequisites
Follow the procedure in
Before working inside your computer.
CAUTION:When servicing the computer, place it on an elevated, clean, and flat surface. Place the display flat on the surface with the stand hanging over the edge. It is recommended to remove the stand to avoid accidental damage to the computer display when servicing.
NOTE:The following procedure is applicable for both Y stand and Isosceles stand.
NOTE: For replacement of stand or display hinges, the replacement kit is shipped with both stand and display hinges, and you must replace both of these components together. Refer to the procedure for
removing the display hinges and
installing the display hinges.
About this task
The following image indicates the location of the stand and provides a visual representation of the removal procedure.
Steps
- Locate the tab on the stand, and push a scribe into the tab to release the stand from the display-assembly base.
- Lift the stand off the display-assembly base.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\