Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Inspiron 24 5410 All-in-One Service Manual

PDF

Installing the microphones

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the microphones and provides a visual representation of the installation procedure.

Image: Installing the mircrophones

Steps

  1. Align and place the microphone module into the slot on the display-assembly base.
  2. Replace the four screws (M2X3.5) that secure the microphone module to the display-assembly base.
  3. Route the microphone cable through the routing guides on the display-assembly base.
  4. Adhere the tape that secures the microphone cable to the display-assembly base.

Next steps

  1. Install the system board.
  2. Install the heat sink.
  3. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive, as applicable.
  4. Install the wireless card.
  5. Install the memory module.
  6. Install the media-card reader.
  7. Install the system-board shield.
  8. Install the hard drive.
  9. Install the I/O cover.
  10. Install the back cover.
  11. Install the stand.
  12. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\