- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Inspiron 24 5410 All-in-One
- Stand
- Back cover
- I/O cover
- Hinges
- Hard drive
- System-board shield
- Memory module
- Wireless card
- Solid-state drive
- Retractable-camera assembly
- Fan
- Speakers
- Coin-cell battery
- Heat sink
- Media-card reader
- Power-button board
- System board
- Microphones
- Antennas
- Display panel
- Base panel
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell Technologies
Inspiron 24 5410 All-in-One Service Manual
Installing the stand
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
NOTE:The following procedure is applicable for both Y stand and Isosceles stand.
NOTE: For replacement of stand or display hinges, the replacement kit is shipped with both stand and display hinges, and you must replace both of these components together. Refer to the procedure for
removing the display hinges and
installing the display hinges.
About this task
The following image indicates the location of the stand and provides a visual representation of the installation procedure.
Insert the stands into the slots on the back cover until they snap into place on the display-assembly base.
Next steps
Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\