OptiPlex 3000 Thin Client Service Manual

Installing the M.2 2230 solid-state drive

If you are replacing a component, remove the existing component before performing the installation procedure.

The following image indicates the location of the solid-state drive and provides a visual representation of the installation procedure.

Image: Installing the M.2 2230 solid-state drive

Align the notch on the M.2 2230 solid-state drive with the tab on the M.2 card slot.
Slide the M.2 2230 solid-state drive at an angle into the M.2 card slot.
Replace the screw (M2x3.5) to secure the M.2 2230 solid-state drive to the system board.
Place the solid-state drive heat sink on the M.2 2230 solid-state drive.
Align the screws on the solid-state drive heat sink to the screw holes on the system board.
Tighten the two captive screws to secure the solid-state drive heat sink to the system board.