Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

OptiPlex 3000 Thin Client Service Manual

PDF

Installing the SMA antenna Location 2

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the SMA antenna and provides a visual representation of the removal procedure.

NOTE:To upgrade to SMA antenna, the internal antenna Location 2 is required to be removed.

Image: Installating the SMA antenna in Location 2

Steps

  1. Remove the filler on the back of the system.
    NOTE:Step one is only applicable for new installation or an upgrade. For replacing an existing component, follow the procedure from step two.
  2. Route the antenna cable through cable clip and the routing guides on the system.
  3. Tilt and align the tab on the antenna with the slot on the chassis.
  4. Insert the antenna bracket into the opening on the system board.
  5. Rotate the antenna bracket to align the SMA antenna assembly with the screw hole on the back view.
  6. Replace the screw (M3x3) to secure the SMA antenna assembly to the system.

Next steps

  1. Install the WLAN card.
  2. Install the side cover.
  3. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\