OptiPlex 3000 Thin Client Service Manual

Loading, Please wait

Screw list

NOTE:When removing screws from a component, it is recommended to note the screw type, and the quantity of screws, and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is restored when the component is replaced.

NOTE:Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when replacing a component.

NOTE:Screw color may vary with the configuration ordered.

Table 1. Screw listThe following table provides the different screws that are used in your OptiPlex 3000 Thin Client.
Component	Screw type	Quantity	Image
Side cover	Thumb screw (#6-32)	1
M.2 2230 solid-state drive heat sink	Captive screw	2	NA
M.2 2230 solid-state drive	M2x3.5	1
WLAN card	M2x3.5	1
Small Form Factor Pluggable (SFP) port	M3x3 M2x3	2 1
Heat sink	Captive screw	4	NA
System board	M3x4 M3x5	2 (1 for M.2 WiFi standoff and 1 for M.2 SSD standoff) 6 (5 for system board and 1 for speaker holder)