Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

OptiPlex 3000 Thin Client Service Manual

PDF

Installing the Small Form Factor Pluggable (SFP) port

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the Small Form Factor Pluggable (SFP) port and provides a visual representation of the installation procedure.

Image: Installing the Small Form Factor Pluggable (SFP) portImage: Installing the Small Form Factor Pluggable (SFP) port

Steps

  1. Slide and insert the M.2 board module into the M.2 board module slot on the chassis.
  2. Replace the screw (M2x3) to secure the M.2 board module to the chassis.
  3. Insert the SFP Net board module through the opening at the back of the system.
  4. Connect the SFP cable to the connector on the system board.
  5. Route the SFP cable through the clip on the system board.
  6. Replace the two screws (M3x3) to secure the SFP Net board module to the chassis.

Next steps

  1. Install the side cover.
  2. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\