Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

bgp default local-preference

Change the default local preference value for routes exchanged between internal BGP peers.

Syntax

bgp default local-preference value

To return to the default value, use the no bgp default local-preference command.

Parameters

value

Enter a number to assign to routes as the degree of preference for those routes. When routes are compared, the higher the degree of preference or local preference value, the more the route is preferred. The range is from 0 to 4294967295. The default is 100.

Defaults

100

Command Modes

ROUTER BGP

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

All routers apply the bgp default local-preference command setting within the AS. To set the local preference for a specific route, use the set local-preference command in ROUTE-MAP mode.

Related Commands

set metric — assigns a local preference value for a specific route.