Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

service-class dot1p-mapping

Configure a service-class criterion based on a dot1p value.

Syntax

service-class dot1p-mapping {dot1p0 value | dot1p1 value | dot1p2 queue | dot1p3 value | dot1p4 value| dot1p5 value | dot1p6 value | dot1p7 value}

Parameters

Enter a dot1p list number and value. The list number range is from 0 to 7. The range is from 0 to 3.

Defaults

For each dot1p Priority, the default CoS queue value is:

dot1p CoS Queue

0 0-7

1 0-7

2 0-7

3 0-7

4 0-7

5 0-7

6 0-7

7 0-7

Command Modes

CONFIGURATION

Supported Modes

Programmable-Mux (PMUX)

Full-Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
8.3.17.0	Supported on the M I/O Aggregator.

Usage Information

To apply dot1p-queue-mapping, use the service-class dynamic dot1p command.