Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show port-channel-flow

Display an egress port in a given port-channel flow.

Syntax

show port-channel-flow port-channel number incoming-interface interface { src-mac address dest-mac address {vlan vlanid | ether-type }} [ src-ip address dest-ip address ] [ src-port number dest-port number ]

Parameters

port-channel number	Enter the keywords `port-channel` then the number of the port channel to display flow information. The range is from 1 to 128.
incoming-interface interface	Enter the keywords `incoming-interface` then the interface type and slot/port or number information: For a 10-Gigabit Ethernet interface, enter the keyword `TenGigabitEthernet` then the slot/port information.
src-mac address	Enter the keywords `src-mac` then the MAC source address in the nn:nn:nn:nn:nn:nn format.
dest-mac address	Enter the keywords `dest-mac` then the MAC destination address in the nn:nn:nn:nn:nn:nn format.
vlan *vlan-id*	Enter the keyword `vlan` then the VLAN ID. The range is from 1 to 4094.
ether-type	Enter the keywords `ether-type` then the ether-value in the XX:XX format.
src-ip address	Enter the keywords `src-ip` then the IP source address in IP address format.
dest-ip address	Enter the keywords `dest-ip` then the IP destination address in IP address format.
src-port number	Enter the keywords `src-port` then the source port number. The range is from 1 to 65536. The default is None.
dest-port number	Enter the keywords `dest-port` then the destination port number. The range is from 1 to 65536. The default is None.

Command Modes

EXEC

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
8.3.17.0	Supported on the M I/O Aggregator.

Usage Information

Because this command calculates based on a Layer 2 hash algorithm, use this command to display flows for switched Layer 2 packets, not for routed packets (use the show ip flow command to display routed packets).

The show port-channel-flow command returns the egress port identification in a given port-channel if a valid flow is entered. A mismatched flow error occurs if MAC-based hashing is configured for a Layer 2 interface and you are trying to display a Layer 3 flow.

The output displays three entries:

Egress port for unfragmented packets.
In the event of fragmented packets, the egress port of the first fragment.
In the event of fragmented packets, the egress port of the subsequent fragments.

NOTE: In the show port-channel–flow command output, the egress port for an unknown unicast, multicast, or broadcast traffic is not displayed.