Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

neighbor distribute-list

Distribute BGP information using an established prefix list.

Syntax

neighbor { ipv6-address | peer-group-name} distribute-list prefix-list-name {in | out}

To delete a neighbor distribution list, use the no neighbor { ipv6-address | peer-group-name} distribute-list prefix-list-name {in | out} command.

Parameters

ipv6-address	Enter the IPv6 address in the x:x:x:x::x format. NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name	Enter the name of the peer group.
prefix-list-name	Enter the name of an established prefix list. If the prefix list is not configured, the default is permit (to allow all routes).
in	Enter the keyword in to distribute only inbound traffic.
out	Enter the keyword out to distribute only outbound traffic.

Defaults

Not configured.

Command Modes

ROUTER BGPV6-ADDRESS FAMILY

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Related Commands

neighbor filter-list — assigns a AS-PATH list to a neighbor or peer group.

neighbor route-map — assigns a route map to a neighbor or peer group.