Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

private-vlan mapping secondary-vlan

Map secondary VLANs to the selected primary VLAN.

Syntax

[no] private-vlan mapping secondary-vlan vlan-list

To remove specific secondary VLANs from the configuration, use the no private-vlan mapping secondary-vlan vlan-list command syntax.

Parameters

vlan-list

Enter the list of secondary VLANs to associate with the selected primary VLAN. The list can be in comma-delimited or hyphenated-range format, following the convention for the range input.

Defaults

none

Command Modes

INTERFACE VLAN

Supported Modes

Full—Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The list of secondary VLANs can be:

Specified in comma-delimited or hyphenated-range format.
Specified with this command even before they have been created.
Amended by specifying the new secondary VLAN to be added to the list.

Related Commands

private-vlan mode — sets the mode of the selected VLAN to community, isolated, or primary.

show interfaces private-vlan — displays the type and status of the PVLAN interfaces.

show vlan private-vlan — displays the PVLANs and/or interfaces that are part of a PVLAN.

show vlan private-vlan mapping — displays the primary-secondary VLAN mapping.

switchport mode private-vlan — sets PVLAN mode of the selected port.