Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ipv6 ospf priority

To determine the Designated Router for the OSPFv3 network, set the priority of the interface.

Syntax

ipv6 ospf priority number

To return to the default time interval, use the no ipv6 ospf priority command.

Parameters

number

Enter the number as the priority. The range is from 1 to 255.

Defaults

1

Command Modes

INTERFACE

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

Setting a priority of 0 makes the router ineligible for election as a Designated Router or Backup Designated Router.

Use this command for interfaces connected to multi-access networks, not point-to-point networks.