Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show ip bgp next-hop

View all next hops (using learned routes only) with current reachability and flap status. This command only displays one path, even if the next hop is reachable by multiple paths.

Syntax

show ip bgp next-hop

Command Modes

EXEC
EXEC Privilege

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The following describes the show ip bgp next-hop command shown in the following example.

Field	Description
Next-hop	Displays the next-hop IP address.
Via	Displays the IP address and interface used to reach the next hop.
RefCount	Displays the number of BGP routes using this next hop.
Cost	Displays the cost associated with using this next hop.
Flaps	Displays the number of times the next hop has flapped.
Time Elapsed	Displays the time elapsed since the next hop was learned. If the route is down, this field displays time elapsed since the route went down.

Example

Dell>show ip bgp next-hop
                                             Next-hop    Via                  RefCount Cost Flaps Time Elapsed
                                             63.114.8.33 63.114.8.33, Gi 12/22   240984   0     0 00:18:25
                                             63.114.8.34 63.114.8.34, Gi 12/22   135152   0     0 00:18:13
                                             63.114.8.35 63.114.8.35, Gi 12/22        1   0     0 00:18:07
                                             63.114.8.60 63.114.8.60, Gi 12/22   135155   0     0 00:18:11
                                             Dell>