Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

PowerProtect Data Manager 19.13 Cyber Recovery User Guide

Cleaning up after a PowerProtect Data Manager recovery

After the PowerProtect Data Manager recovery is completed, delete the sandbox and DD boost storage unit.

About this task

You can perform this task by using the Cyber Recovery UI or the CRCLI.

Steps

  1. Delete the sandbox that was created when you initiated the PowerProtect Data Manager recovery.
    1. From the Main Menu, click Recovery and then click Recovery Sandboxes from the top of the Recovery pane.
    2. Select the recovery sandbox.
    3. Click Cleanup.
    The sandbox is deleted, and the Cyber Recovery software reverts the PowerProtect Data Manager software to the snapshot that was created when you initiated the recovery.
  2. Optionally, on the DD system, run the filesys clean start command.
    This step deletes the DD Boost storage unit. If you choose not to perform this step, the DD Boost storage unit is deleted during the next scheduled cleaning operation.

Results

The system is ready for another recovery operation.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\