- Notes, cautions, and warnings
- Preface
- Introduction
- Getting Started
- Configuring and Managing Storage and Applications
- Configuring and Managing Multiple Network Links for CyberSense
- Configuring and Managing Policies and Copies
- Managing Reports
- Monitoring
- Performing a PowerProtect Data Manager Recovery with Cyber Recovery
- Recovering PowerProtect Data Manager data
- Meeting prerequisites for a PowerProtect Data Manager recovery
- Initiating a PowerProtect Data Manager recovery in the Cyber Recovery UI
- Running a PowerProtect Data Manager recovery check
- Cleaning up after a PowerProtect Data Manager recovery
- Performing postrecovery steps for a PowerProtect Data Manager recovery
- Administration
- Administration overview
- Manually securing and releasing the Cyber Recovery vault
- Managing users
- Managing login sessions
- Setting up an email server
- Managing Cyber Recovery password expiration
- Resetting Cyber Recovery passwords
- Resetting the IP address on the management host
- Changing the network gateway on the Cyber Recovery server
- Updating the SSL security certificate
- Configuring a daily activity report
- Configuring a telemetry report
- Changing time zones
- Changing the log level
- Collecting logs for upload to support
- Log file rotation
- Protecting the Cyber Recovery configuration
- Retrieving your preserved Cyber Recovery configuration
- Setting up a maintenance schedule
- Cyber Recovery disaster recovery
- Troubleshooting
PowerProtect Data Manager 19.13 Cyber Recovery User Guide
Locking copies automatically
For deployments that are running DD OS Version 7.6 and earlier, use the automatic retention lock feature to lock copies automatically.
Prerequisites
The Cyber Recovery vault DD system must run PowerProtect DD OS Versions 6.2.1.50 through Version 7.6.
About this task
NOTE:
- Do not configure the automatic retention lock feature on a policy on a deployment that is running DD OS Version 7.7 and later. Later versions of DD OS and the Cyber Recovery software provide retention locking automatically when the data is copied. Using the automatic retention lock feature with this DD configuration introduces some unnecessary constraints, such as the inability to create an unlocked copy.
- If your deployment uses the CyberSense software, we do not recommend using the automatic retention lock feature.
If the automatic retention lock feature is enabled, the Cyber Recovery software automatically locks any copies that are created on the DD system. This feature supports both Retention Lock Compliance and Retention Lock Governance.
When you enable automatic retention locking on a policy:
- The Cyber Recovery UI lists only the Secure Copy, Copy Lock, and Sync policy actions.
- You cannot disable automatic retention locking.
Steps
- Log in to the Cyber Recovery UI.
- Select Policies from the Main Menu.
-
Either add a policy or edit an existing policy.
The Add Policy or Edit Policy window is displayed.
-
Click the checkbox to enable the automatic retention lock feature.
A Cyber Recovery copy is fully retention locked when all files are copied to the repository and a five minute delay has been applied.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\