iDRAC9 Redfish API Guide Firmware version: 4.20.20.20

PDF

Supported Action — GetRAIDLevels

Description

The GetRAIDLevels action is used to determine the possible choices of RAID Levels to create virtual disks. If the list of physical disks is not provided, this action accesses information for all the connected disks.

URL

/redfish/v1/Dell/Systems/<ComputerSystem-Id>/DellRaidService/Actions/DellRaidService.GetRAIDLevels

Supported HTTP Method and Privileges


HTTP Method	Required Privilege
POST	Login

Supported Parameters

NOTE A star (*) indicates a required parameter, else the parameter is optional.


Parameter	Type	Value	Description
BlockSizeInBytes	ENUM	All, 4096, 512	The parameter specifies the physical drive block size in bytes.
DiskEncrypt	ENUM	All, FDE, NonFDE	The parameter specifies the drive encryption capability.
DiskType	ENUM	All, HDD, SSD	The parameter specifies the type of the drive.
Diskprotocol	ENUM	AllProtocols, SATA, SAS, NVMe	The parameter specifies the type of drive protocol.
FormFactor	ENUM	All, M.2	This parameter is used to specify the form factor of drives and shall be one of the following: 0—Include all 1—Include only BOSS M.2
PDArray	Array of strings		Array of FQDDs where each identifies a physical drive.
T10PIStatus	ENUM	All, T10PICapable, T10PIIncapable	The parameter specifies the T10-Protection Information (PI) capability status.
TargetFQDD	String		FQDD of target device (Controller).

Supported Status Codes


HTTP Status Code	Extended Information	Error Message Code
400		STOR003, STOR004, STOR006, STOR007, STOR030, STOR037, STOR038