iDRAC9 Redfish API Guide Firmware version: 4.20.20.20

Supported Action — SetControllerKey

The SetControllerKey action is used to set the key on controllers and set the controller in Local key Management (LKM) to encrypt the drives.

/redfish/v1/Dell/Systems/<ComputerSystem-Id>/DellRaidService/Actions/DellRaidService.SetControllerKey


HTTP Method	Required Privilege
POST	Login

NOTE A star (*) indicates a required parameter, else the parameter is optional.


Parameter	Type	Description
Key	String	The parameter specifies the key passcode. The Key shall be maximum of 32 characters in length, where the expanded form of the special character is counted as a single character. The Key shall have at least one character from each of the following sets. Upper case, lower case, number, special character, The special characters in the following set need to be passed as mentioned below: &->&, < -><, >->>, "->", ' ->'"
Keyid	String	Key identifier describes the key. The key ID shall be maximum 32 characters in length and must not have any white spaces.
TargetFQDD	String	This parameter is the FQDD of the target device (Controller).


HTTP Status Code	Extended Information	Error Message Code
400		STOR003, STOR004, STOR006, STOR007, STOR021, STOR022, STOR030, STOR037, STOR038