Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Inspiron 24 5410 All-in-One Service Manual

Installing the display panel

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of display panel and provides a visual representation of the installation procedure.

Image: Installing the display panel

Image: Installing the display panel

Steps

  1. Slide and insert the display panel into the slot on the display-assembly base.
  2. Route the display-backlight cable, touchscreen cable, and display cable on the display panel through the slots on the display-assembly base.
  3. Place the display-assembly base on a clean and flat surface with the display panel facing down.
  4. Replace the 10 screws (M3x5) that secure the display panel to the display-assembly base.
  5. Replace the five screws (M3x3) that secure the display panel to the display-assembly base.
    NOTE:The screws that secure the middle frame and display panel to the display-assembly base are silver in color and etched with "LCD" around the screw holes.

Next steps

  1. Install the heat sink.
  2. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive, as applicable.
  3. Install the wireless card.
  4. Install the memory module.
  5. Install the system board.
  6. Install the system-board shield.
  7. Install the hard drive.
  8. Install the I/O cover.
  9. Install the back cover.
  10. Install the stand.
  11. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\