Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Inspiron 24 5410 All-in-One Service Manual

PDF

Removing the system board

Prerequisites

  1. Follow the procedure in Before working inside your computer.
    NOTE:Your computer’s Service Tag is stored in the system board. You must enter the Service Tag in the BIOS setup program after you replace the system board.
    NOTE:Replacing the system board removes any changes that you have made to the BIOS using the BIOS setup program. You must make the appropriate changes again after you replace the system board.
    NOTE:Before disconnecting the cables from the system board, note the location of the connectors so that you can reconnect the cables correctly after you replace the system board.
  2. Remove the stand.
  3. Remove the back cover.
  4. Remove the I/O cover.
  5. Remove the hard drive.
  6. Remove the system-board shield.
  7. Remove the memory module.
  8. Remove the wireless card.
  9. Remove the M.2 2230 solid-state drive or M.2 2280 solid-state drive, as applicable.
  10. Remove the heat sink.

About this task

The following image indicates the connectors on your system board.
Figure 1. System-board connectors
Image:System-board connectors
  1. Solid-state drive slot
  2. Touchscreen-cable connector (optional)
  3. Camera-cable connector
  4. Backlight-cable connector
  5. Fan-cable connector
  6. Coin-cell battery
  7. Memory-module slot (DIMM1)
  8. Memory-module slot (DIMM2)
  9. Speaker-cable connector
  10. Microphone-module cable connector
  11. Media-card reader cable connector
  12. Wireless-card slot
  13. Power-button board cable connector
  14. Display-cable connector

The following image indicates the location of system board and provides a visual representation of the removal procedure.

Image: Removing the system board

Image: Removing the system board

Steps

  1. Disconnect the touchscreen cable from the system board.
    NOTE:This cable is only available on computers that support touch option.
  2. Disconnect the camera cable from the system board.
  3. Disconnect the backlight cable from the system board.
  4. Disconnect the fan cable from the system board.
  5. Disconnect the speaker cable from the system board.
  6. Disconnect the microphone-module cable from the system board.
  7. Open the latch and disconnect the media-card reader cable from the system board.
  8. Open the latch and disconnect the power-button board cable from the system board.
  9. Open the latch and disconnect the display cable from the system board.
  10. Remove the six screws (M3x5) that secure the system board to the display-assembly base.
  11. Remove the solid-state drive screw mount (M3x4) that secures the system board to the display-assembly base.
  12. Lift the system board off the display-assembly base.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\