- Notes, cautions, and warnings
- Views of Latitude 5340/Latitude 5340 2-in-1
- Set up your Latitude 5340/Latitude 5340 2-in-1
- Specifications of Latitude 5340/Latitude 5340 2-in-1
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports and slots
- Internal slots
- Wireless module
- WWAN module
- Audio
- Storage
- Keyboard
- Keyboard function keys
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Fingerprint reader (optional)
- Sensor
- GPU—Integrated
- Hardware security
- Smart-card reader
- Operating and storage environment
- Dell support policy
- ComfortView Plus
- Using the privacy shutter
- Dell Optimizer
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locating the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 5340/Latitude 5340 2-in-1 Owner's Manual
Installing the palm-rest
Prerequisites
CAUTION:The information in this section is intended for authorized service technicians only.
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the palm-rest and provides a visual representation of the installation procedure.
Steps
Place the palm-rest assembly on a flat surface.
Next steps
NOTE: The system board can be installed with the heat sink attached in order to simplify the procedure and preserve the thermal bond between the system board and heat sink.
- Install the SIM card slot filler (for computers without nano-SIM card option).
- Install the display assembly.
- Install the speakers.
- Install the smart card reader (optional).
- Install the power button or power button with optional fingerprint reader.
- Install the system board.
- Install the heat sink.
- Install the fan.
- Install the WLAN card.
- Install the WWAN 4G card or WWAN 5G card.
- Install the M.2 2230 solid-state drive.
- Install the battery.
- Install the base cover.
- Install the SIM card tray (for computers with nano-SIM card option).
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\