- Notes, cautions, and warnings
- Views of Latitude 5340/Latitude 5340 2-in-1
- Set up your Latitude 5340/Latitude 5340 2-in-1
- Specifications of Latitude 5340/Latitude 5340 2-in-1
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Wireless module
- WWAN module
- Audio
- Storage
- Keyboard
- Keyboard function keys
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Fingerprint reader (optional)
- Sensor
- GPU—Integrated
- Hardware security
- Smart-card reader
- Operating and storage environment
- Dell Support policy
- ComfortView Plus
- Using the privacy shutter
- Dell Optimizer
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 5340/Latitude 5340 2-in-1 Owner's Manual
Installing the WWAN 5G card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the WWAN 5G card and provides a visual representation of the installation procedure.
NOTE:For instructions on how to find your computer's IMEI (International Mobile Station Equipment Identity) number, see the knowledge base article
000143678 at
www.dell.com/support.
Steps
- Connect the antenna cables to the connectors on the WWAN 5G card.
The following table provides the antenna-cable color scheme for the WWAN 5G card supported by your computer.
Table 1. Antenna-cable color schemeThe following table provides the antenna-cable color scheme for the WWAN card of your computer. Connectors on the WWAN card Antenna-cable color Silkscreen marking D/G Black with a thin white stripe ANT3 D/G △ (white triangle) M2 Blue ANT2 M2 △ (white triangle) M1 Orange ANT1 M1 △ (white triangle) M White with a thin gray stripe ANT0 M △ (white triangle) - Align the notch on the WWAN card and slide the WWAN 5G card at an angle into the WWAN-card slot.
- Align and place the WWAN-thermal shield on the WWAN 5G card, and tighten the two screws (M2x3).
- Align and place the WWAN-card bracket the WWAN 5G card and tighten the screw (M2x3.5).
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\