- Notes, cautions, and warnings
- Views of Latitude 5340/Latitude 5340 2-in-1
- Set up your Latitude 5340/Latitude 5340 2-in-1
- Specifications of Latitude 5340/Latitude 5340 2-in-1
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports and slots
- Internal slots
- Wireless module
- WWAN module
- Audio
- Storage
- Keyboard
- Keyboard function keys
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Fingerprint reader (optional)
- Sensor
- GPU—Integrated
- Hardware security
- Smart-card reader
- Operating and storage environment
- Dell support policy
- ComfortView Plus
- Using the privacy shutter
- Dell Optimizer
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locating the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 5340/Latitude 5340 2-in-1 Owner's Manual
Removing the keyboard assembly
Prerequisites
CAUTION:The information in this section is intended for authorized service technicians only.
- Follow the procedure in Before working inside your computer.
- Remove the SIM card tray (for computers with nano-SIM card option).
- Remove the base cover.
- Remove the battery.
- Remove the M.2 2230 solid-state drive.
- Remove the WWAN 4G card or WWAN 5G card.
- Remove the WLAN card.
- Remove the fan.
- Remove the system board.
- Remove the power button or power button with optional fingerprint reader.
- Remove the smart card reader (optional).
- Remove the speakers.
- Remove the display assembly.
About this task
NOTE: The system board can be removed with the heat sink attached to simplify the procedure and preserve the thermal bond between the system board and heat sink.
The following images indicate the location of the keyboard assembly and provide a visual representation of the removal procedure.
Steps
- Lift the latch and disconnect the keyboard cable and keyboard backlit cable.
- Lift the mylar covering the screws.
- Remove the eighteen screws (M2x2) that secure the keyboard assembly to the palm-rest assembly.
- Carefully lift the keyboard assembly from the palm-rest assembly.
- Flip the keyboard assembly.
- Remove the two screws (M2x2) that secure the keyboard to the keyboard bracket.
- Remove the keyboard from the keyboard bracket.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\