Replace the 40 (M1.6x1.5) screws on the keyboard to secure it to the palmrest assembly. Several of the screws are covered by the touchpad flexible flat cable, LED flexible flat cable (FFC), keyboard flexible printed circuit (FPC), and copper foil. Technicians must peel back these FFC/FPC/foil in order to access the keyboard screws.
Install the middle battery bracket [1] and secure it using two (M1.6x1.5) screws [2].
Stick the keyboard and backlight FPC cables to the keyboard [3].
Install left battery bracket [4] and secure it using single (M1.6x1.5) screw [5].
Stick the two pieces of LTE antenna module copper foil [1, 3] and LTE AUX cable on the keyboard [2].
Route and stick the smart card FPC cable [4] on the keyboard and connect it to the USH board [5].
Stick the USH board cable [1], touchpad cable [2], and LED board cable [3] on the keyboard base.