Install the system board in the computer [1] and install the five (M2x3) screws securing it to the computer.
NOTE: After removing all brackets and disconnecting all cables, there are five screws that secure the system board to the palmrest. One of the screw is covered by the Real Time Clock (RTC) battery. Technicians must first peel the RTC battery off the system board in order to access all the screws for the system board.
Install the USB Type-C bracket [1] on the system board and secure it using two (M2x4) screws [2] on the system board.
Install the SSD bracket [3] and secure it using a single (M2x2) screw [4] to the system board.
Connect the Power button/fingerprint reader cable to the system board [1].
Install the power button/finger print reader bracket [2] on the system board and secure it using the single (M2x2) screw [3].
Connect the LTE P-sensor and isolator antenna cables [4] on the system board.
Connect the LTE MAIN and AUX antennae cables [5] on the system board.
Connect the following power button cable to the system board [1].
Connect the USH board cable [2] and keyboard with backlight cable [3] to the system board.
Connect the touchpad cable [4] and LED board cable [5] to the system board.
Install the coin cell [1] on the system board and connect its cable to the system board [2].
Connect the display cable to the system board [3] and flip close the actuator [4].
Secure the display cable connector by sticking the tape on the system board [5].