Dell Latitude 9410 Service Manual

Installing the solid state drive

1. Align and slide the solid state drive (SSD) module into the connector on the system board.
   
2. Place the SSD shield on the SSD module [1] and replace the single (M2x2) screw [2] to secure it to the system board.
   NOTE: If the model is shipped with full-length SSD, then replace the two (M2x2) screws to secure the SSD shield to the system board.

   
3. Affix the black tape [1] and the metal foil [2] to secure the SSD shield in place.