NOTE: For the system shipped with a WWAN card, there is an L-shaped bracket (P-sensor bracket) that covers the four WWAN LTE antenna cable connections to the system board. The screw that secures the bracket to the system also helps secure the fan to the system. Technicians must first remove the bracket before removing the fan and then reinstall the bracket after the fan is reinstalled.
Peel off the Mylar sheet from the system board.
Disconnect the fan cable [1] from the connector on the system board [1].
Partially peel off the metal foil [2] and the black tape [3] on the SSD shield.
Remove the single (M2x2) screw [1] that secures the WWAN P-sensor bracket to the system board.
Remove the WWAN P-sensor bracket [2] from the system board.
Partially peel off the padded gasket [1] from the fan case.
Remove the single (M2x2) screw [2] that secures the fan to the system board.
CAUTION: There are cushions, partially obstructing the palmrest, on the bottom side of the fan. Technicians should not lift the fan directly up, as it may damage the fan.
Partially lift the left side of the fan and slide it to the left to remove it from the computer.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\