Peel off the USH board cable [1], touchpad cable [2], and LED board cable [3] from the keyboard base.
Peel back the two pieces of LTE antenna module copper foil [1, 3] and LTE AUX cable from the keyboard [2].
Disconnect the smartcard reader FPC from the USH board [4] and peel off the FPC cable from the keyboard [5].
Remove the two (M1.6x1.5) screws [1] to remove the middle battery bracket [2] from the computer.
Peel off the keyboard and backlight FPC cables from the keyboard [3].
Remove the single (M1.6x1.5) screw [4] to remove the left battery bracket [5] from the computer.
Remove the 40 (M1.6x1.5) screws that secure the keyboard to the palmrest assembly. Several of the screws are covered by the touchpad flexible flat cable, LED flexible flat cable (FFC), keyboard flexible printed circuit (FPC), and copper foil. Technicians must peel back these FFC/FPC/foil in order to access the keyboard screws.
Lift the keyboard off the palmrest assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\