Dell Latitude 9410 Service Manual

Installing the display assembly

1. Install the display assembly with hinges open at 180º aligned to the computer [1].
2. Replace the six (M2.5x3.5) screws [1] that secures the display hinges to the computer [2].
   
3. Connect the display cable [1] to the connector on the system board.
4. Close the latch [2] and adhere the tape on the display cable [3].
   
5. Route the camera and touch screen FPC and adhere it on the heatsink shield [1].
6. Connect the camera and touch screen FPC to the connector on the system board [2] and stick the Mylar sheet on the system board [3].