Partially peel off the Mylar sheet [1] from the system board.
Disconnect the camera and touch screen FPC cable [2] from the connector on the system board.
Peel off the camera and touch screen FPC cable from the heatsink shield [3].
Peel off the tape on the display cable [1].
Pry the retention clips on both sides and flip open the latch [2].
CAUTION: The connector for the display cable features a latch that locks it in place on the system board which technicians must flip open in order to disconnect the display cable from the system board. After flipping open the latch, technicians must grasp the left and right sides of the cable's connector head and disconnect the display cable from the system board in a direct upward motion to prevent damage to the connector's pins.
Disconnect the display cable from the connector on the system board [3].
Remove the six (M2.5x3.5) screws [1] that secures the display hinges to the computer.
Lift the display assembly off the computer [2].
NOTE: The display assembly is a Hinge-Up Design (HUD) assembly and cannot be further disassembled once it is removed from the bottom chassis. If any components of the HUD assembly are malfunctioning and need to be replaced, replace the entire display assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\