Dell Latitude 9410 Service Manual

Removing the solid state drive

1. Peel off the metal foil [1] and the black tape [2] that partially covers the solid state drive (SSD) cover.
   
2. Remove the single (M2x2) screw [1] that secures the SSD shield to the system board.
   NOTE: If the model is shipped with full-length SSD, then remove the two (M2x2) screws that secures the SSD shield to the system board.
3. Lift to remove the SSD shield from the system board [2].
   
4. Slide and remove the SSD module from the connector on the system board.