Latitude 3590 Owner’s Manual

Removing the display assembly

1. Follow the procedure in Before working inside your computer.
2. Remove the:
   1. base cover
   2. Removing the WLAN card
   3. Removing the WWAN card
3. Remove the eDP cable from its connector on the system board [1] and unroute the cable from the routing channel on the system fan [2].
4. Peel off the adhesive tape securing the eDP cable to the system [3].
5. Unroute the eDP cable from the hook of the right LCD hinge and routing clips on the system [4].
6. Unroute the WLAN cables from the routing channel [5] .
   
7. Then, open the palm-rest assembly to at least 90-degrees and place the system on the edge of a table so that the palm rest is laying flat on the table and the display assembly is over the edge.
   CAUTION: Hold the system firmly when the system is placed at this position.

   
8. Remove the 6 (M2.5x2.5) screws [1] and lift the display assembly away from the computer [2].
   CAUTION: Hold the display assembly firmly when you place the display assembly at a 90 degree angle to the palm rest, to avoid damaging the display assembly.