- Notes, cautions, and warnings
- Working on your computer
- Disassembly and reassembly
- Recommended tools
- Screw size list
- SIM tray
- SD card—optional
- Base Cover
- Battery
- WLAN Card
- WWAN card – optional
- VGA board
- Memory Module
- Hard drive
- M2. SATA Solid State Drive (SSD)
- Speakers
- Coin cell battery
- Heat sink
- System Fan
- Input-Output board, SD card and coin cell battery holder
- Fingerprint reader – optional
- Touchpad panel
- Display assembly
- DC-In Port
- Power button board
- LCD Bezel
- Camera
- LCD Panel
- LCD Hinge
- eDP and camera cable
- System board
- Palmrest
- Technical specifications
- Technology and components
- System setup options
- Boot Sequence
- Navigation keys
- System Setup overview
- Accessing System Setup
- General screen options
- System Configuration screen options
- Video screen options
- Security screen options
- Secure Boot screen options
- Intel Software Guard Extensions screen options
- Performance screen options
- Power management screen options
- POST behavior screen options
- Virtualization support screen options
- Wireless screen options
- Maintenance screen options
- System logs screen options
- SupportAssist system resolution
- SupportAssist system resolution
- Updating the BIOS in Windows
- Updating your system BIOS using a USB flash drive
- System and setup password
- Software
- Troubleshooting
Latitude 3590 Owner’s Manual
Installing VGA board
- Place the VGA board in its slot on the system.
- Replace the two M2x3 screws to secure the VGA board to the system.
- Connect the VGA daughter board cable to the VGA daughter board.
- Install the:
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\