Latitude 3590 Owner’s Manual

Installing the display assembly

1. Place the display assembly on the palm rest at a 90 degree angle and align with the screw holders on the palm rest.
   NOTE: Hold the display assembly firmly when you place the display assembly on the plamrest at a 90 degree angle, to avoid damaging the display assembly.
2. Tighten the 6 (M2.5x2.5) screws to secure the display assembly to the computer.
3. Turn over the computer
4. Route the WLAN cables through the routing channel.
5. For models shipped with a WWAN card, the WWAN antennas must be routed underneath the right display hinge and above the VGA daughter board cable, and then secured with an adhesive tape on the power button daughter board.
6. Route the eDP cable through the hook of the right LCD hinge and routing clips on the system.
7. Affix the adhesive tape to secure the eDP cable to the system.
8. Route the display cable through the routing channel on the system fane and connect the display cable to its connector on the system board.
9. Install the:
   1. Installing the WWAN card
   2. Installing the WLAN card
   3. base cover
10. Follow the procedure in After working inside your computer