OptiPlex 7050 Small Form Factor Owner's Manual

PDF

Installing the intrusion switch

  1. Insert the intrusion switch into the slot on the chassis.
  2. Connect the intrusion switch cable to the system board.
  3. Install the:
    1. cover
  4. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\