OptiPlex 7050 Small Form Factor Owner's Manual

PDF

Installing the power supply unit or PSU

  1. Insert the PSU in the chassis and slide it toward the back of the computer to secure it.
  2. Tighten the screws to secure the PSU to the back of the computer.
  3. Route the PSU cables through the retention clips.
  4. Connect the power cables to the system board.
  5. Install the:
    1. optical drive
    2. 2.5–inch drive assembly
    3. bezel
    4. cover
  6. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\