OptiPlex 7050 Small Form Factor Owner's Manual

PDF

Removing bezel

NOTE:Depending on the configuration you order, you may see either of the heat sinks as shown in the image below.

Heat sink

  1. Follow the procedure in Before working inside your computer.
  2. Remove the cover.
  3. To remove the front bezel:
    1. Lift the tabs to release the front bezel from the computer [1].
    2. Remove the front bezel from the computer [2].
    Figure displaying how to remove the bezel from the computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\