PowerScale OneFS 9.8.0.0 Web Administration Guide

Configure CEE for Windows

After you install CEE for Windows on a client system, you must configure additional settings through the Windows Registry Editor (regedit.exe).

1. Open the Windows Registry Editor.
2. Configure the following registry keys, if supported by your audit application:

   Table 1. Window Registry Editor SettingsThe following table displays information about how to configure each setting.

   Setting	Registry location	Key	Value
   CEE HTTP listen port	[HKEY_LOCAL_MACHINE\SOFTWARE\EMC\CEE\Configuration]	HttpPort	12228
   Enable audit remote endpoints	[HKEY_LOCAL_MACHINE\SOFTWARE\EMC\CEE\CEPP\Audit\Configuration]	Enabled	1
   Audit remote endpoints	[HKEY_LOCAL_MACHINE\SOFTWARE\EMC\CEE\CEPP\Audit\Configuration]	EndPoint	<EndPoint>

   NOTE:

   • The HttpPort value must match the port in the CEE URIs that you specify during OneFS protocol audit configuration.
   • The EndPoint value must be in the format <EndPoint_Name>@<IP_Address>. You can specify multiple endpoints by separating each value with a semicolon (;).
   The following key specifies a single remote endpoint:

   [HKEY_LOCAL_MACHINE\SOFTWARE\EMC\CEE\CEPP\Audit\Configuration] EndPoint = AuditApplication@10.7.1.2

   The following key specifies multiple remote endpoints:

   [HKEY_LOCAL_MACHINE\SOFTWARE\EMC\CEE\CEPP\Audit\Configuration] EndPoint = AuditApplication@192.168.22.3;AuditApplication@192.168.33.2

3. Close the Windows Registry Editor.