Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R550 Installation and Service Manual

PDF

Removing the right control panel

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the air shroud.
  4. Remove the drive backplane cover.
  5. Remove the cooling fan cage assembly.

Steps

  1. Disconnect the right control panel cable and the VGA cable from the connectors on the system board.
    NOTE: Observe the routing of the cable as you remove it from the system.
  2. Remove the cable from cable clip.
  3. Using the Phillips #1 screwdriver, remove the screws that secures the right control panel and cable cover to the system.
  4. Holding the right control panel assembly, remove the control panel along with the cable from the system.
    NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Removing the right control panel
    This image shows the removal of the right control panel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\