If they are supported, IOA templates can be deployed to any target device. If the target device is repurposed or bare-metal, configurations cannot be reverted.
Prerequisites
NOTE:To perform any tasks on OpenManage Enterprise, you must have necessary role-based user privileges and scope-based operational access to the devices. See
Role and scope-based access.
Before you begin deploying an IOA deployment template, ensure that:
The firmware version of the target device should be the same as the IOA deployment template.
Only alphanumeric, dash, underscore, and space are used as special characters in the
Template Name. To edit the template name see
Edit IOA deployment template.
Only the following cross-template deployments are supported:
Table 1. Supported cross-template deploymentsThe following table lists the supported cross-template deployments.
IOA Deployment template mode
Supported IOA template modes of target
Standalone
Standalone, PMUX
Programmable MUX (PMUX)
PMUX, Standalone
VLT
VLT
After job submission, the console validates the service tag of the target system to ensure that the operation is performed on the correct system. If the verification fails, the job completes with errors, and the task execution history detail shows the following:
Running
Verifying if the device Service Tag is valid.
The device Service Tag could not be verified.
Task Failed With Errors.
Check the system to ensure that the IP address has not changed since the last discovery was completed. Remediate by discovering the system with the updated IP address, and retrying the operation.
About this task
CAUTION:Ensure that only the appropriate devices are selected for deployment. After deploying a deployment template on a repurpose and bare-metal device, it might not be possible to revert the device to its original configuration.
Steps
On the
Configuration > Templates screen, choose the IOA template to deploy, enable the corresponding checkbox, and click
Deploy Template.
In the
Deploy Template: <template_name> dialog box, under
Target:
In the
Host Names dialog box, you can change the
Host name of the target IOA device. Click
Next.
In the
Advanced Options dialog box: select
Preview Mode to simulate the deployment or select
Continue On Warning to deploy the template and ignore the warnings that are encountered. Click
Next.
Select
Preview Mode to simulate the deployment.
Select
Continue On Warning to deploy the template, and ignore the warnings that are encountered.